About

Based in Wellington, New Zealand - I am passionate about 3D printing and assuring the best quality is achieved for the product. 

I will specify what plastic is used for each product but normally it is either:
PLA - hardy easy plastic for normal prints

PETG- used when water or heat resistance is an issue (planters or coasters)

I believe 3D printing is a much better alternative for the environment. I try to print on demand as much as possible - which means a longer turn around time to the customer, but I am not producing oodles of plastic waste like mass produce products are. 

Where available, I use bio-degradable or recycled plastic filaments to ensure an eco friendly alternative. 

Commercial Licenses - All products listed are either of my own design or the Commercial Rights are held by myself and one of the following parties - Elle Studio, ForgeCore, Modern Machine.